Server room design is basically a collection of many smaller design aspects and fiber optic cable installation is one of the major elements in this. For a fruitful installation of fiber optic cables, you generally need to consider some important rules. Here are some of them which hold much of importance during the process:

Minimum Bend Radius: One of the most important factors during fiber optic installation is the upkeep of minimum bend radius. For instance, if the fiber cables are bent more than the least bend radius, it may lead to broken fibers and undue attenuation. Also, when the bend comes to a relaxed mode and there are no damages in the elements of cable, the attenuation should also come back to normal. Max. Vertical Rise: The vertical rise in the in the optical fiber cables is a function of the tensile strength and weight of the cable. This also portrays the max. vertical distance to which the cable could be installed without any intermediary support points. Here are a few guidelines of vertical installation: The vertical cable should possibly be secured by a split mesh grip at the topmost point of the run. The attachment point should comply with the minimum bend radius of cable while the cable is held securely. Secure long vertical cable only when the maximum rise is achieved. Max. Tensile Rating: It is not advisable to exceed the max. tensile rating of the fiber cable during its installation. And for this value, you can trust the one specified by the manufacturer. Also, you should monitor the cable’s tension while a mechanical device for pulling is employed. Duct Utility: It is recommended to keep the fill ratio to less than 50 percent by area, when you pull lengthy cables through conduits or ducts. For instance, a cable could tend to be a 0.71 inch outside the cable dia. and a 1 inch inside the diameter duct. Cable Protection: In order to protect your cables in the data center, it is important to ensure that you install the inner duct as straight as possible. If it tends to have some twists, this could lead to an increase in cable pulling tension. Preconnectorized Data Optic Cables: If you are ordering the factory connectorized data cables, it is important to consider the preconnectorized assembly’s size and the pulling grip etc. There are protective pulling grips which are available to safeguard the connectors, but the outside diameter of the grip could be a hindrance in small conduits and inter-ducts. The Cable Slack:

A bit of slack cable, say about 20 to 30 feet, can be extremely useful when it comes to cable repairs and relocation etc. When it comes to designing your server room, any of the aspects relating standby power generators or fiber optic installation should be planned very carefully. And needless to mention, consulting the experts of data center design, construction and management could always be a better aspect for the most effective results. Visit Our Website:https://mercurypower.net/data-cable-installation/fibre-optic-installation